Functional Details of the EcoSol Heat Pump by ecoTec EnergyModulating low temperature circuit and water heating to constant high temperaturesThe EcoSol heat pump modulates its performance at a uniform compressor speed and depending on the outside temperature. So the rooms to be heated will be heated directly and quickly, there is no need to load the buffer first. Patented technology allows adaptation of the heating performance from 0 to 100%, or, in other words, heating single rooms up to entire buildings directly and efficiently.Uneconomical clock-pulse operation of the heat pump is excluded by the established control unit StarControl and a sophisticated hydraulic design. Due to an integrated heating gas system approximately 10% of the performance are available for water heating (52°C / 125 °F) via a uniformly controlled high-temperature system, whereby the modulating part for quick room heating is not affected. The heating water, which is heated by the gas, is stored in the upper third of the buffer. If warm water is needed, this is used to provide instant warm water by a flash hot water heater based on the heat exchanger principle. It protects your health, since growth of legionella in drinking water is prevented, and it saves energy, which would otherwise be necessary to run an anti-legionella circuit. |
